Accommodation unit

Chassis GAZ-33088 Sadko

AWD
 Wheel formula 4х4
autonomous prestarting heater
 Type of fuel –diesel,
YaMZ 534 engine, euro 5
 Single-row cabin
 Color of cabin – green
 2 (two) seats
 Seat belts - 2 pieces.
ButtonGLONASS Era

Tuning of the basic car

1. Additional fuel tank, 170 l.
2. Heating up of fuel system (two fuel tanks, filter, fuel tank outlet)
3. Mechanical winch, 4.5 t length of cable – 50 m.
4. Rear screen in cabin - sliding.

Main characteristics of the van:

 Van - steel framedwithalcove above cabin (rectangular type) (painted in 2 layers by two-component phosphatizing soil with acid hardener and polyurethane - enamel, providing high adhesion to the painted surface and corrosion prevention);
 Base of the van ("stretcher") - welded from longitudinal longerons and cross beams, painted in 2 layers by the two-component phosphatizing soil with acid hardener and polyurethane soil - enamel, providing high adhesion to the painted surface and corrosion prevention;
 Dimensions – 3700х2340х1950 mm.;
 External covering - plated metal,
 Colour - green,
 High quality sealed joints;
 Internal covering – decorative MDF, 10 mm. light color;
 Insulation – expanded polystyrene, 80 mm.;
Door - Rearsingle;
 Ladder - sliding 1 piece with support on ground.;
 Windows double – 3 pieces: 2 – sliding on each side of the van; one window sliding in front wall of the van at the level of window in cabin;
 Lighting – 4 ceiling plafonds;
 Floor - plywood, linoleum;
 Tow bar on rear wall of the van with the lifting gear

Additional equipment in the van:

1. Tosol(antifreeze) oven from the car engine.
2. Lockers, 2 pieces with back, 2 meters long, transformed to continuous sofa in all width of the van
3. Luggage compartment on roof of the van with ladder, the ladder is located on rear wall of the van (wide, convenient)
4. Oven ‘TermoforЗолушка’ 2016, with equipped place in the rearpart of the van
5. "Complete kitchen" length - 900 mm. table-top, two door under table-top, with shelves. Boxes over table-top

The process of ordering machinery

1
Consultation on the car and equipment
2
Conference call with the Customer
3
Individual discount available
4
Conclusion of an agreement (contract)
5
Reconcile the 3D model with the design department
6
Start the production cycle
7
Readiness alert
8
Shipment date negotiation
9
Delivery
Services